PANEL XP 2 x 18 dBi antenna 1920

PANEL XP 2 x 18 dBi antenna 1920 - 2170 MHz LTE

Untitled Document

This antenna is designed to be used in places where LTE signal level is to low and doesn't allow correct voice and data transmission through the modem. LTE antenna PANEL XP allows to significantly strengthen the radio signal used to implement the transmission of MIMO LTE 5G. Use of the antenna connected to the modem, can significantly increase the speed of transmission by increasing the signal level, and changes to its modulation. The antenna was made using microstripes technology and from the very best materials and is fully weatherproof (humidity, wind, UV). The PANEL XP antenna has an advanced mounting system, which allows easy azimuth and horizont correction.

Notice! In cooperation with networks of LTE antenna polarization should be set obliquely -45 and + 45 at the same time. Information on the current polarity is located on the label at the back of the antenna. The antenna must be set according to the label.

Check also : UMTS pigtails antenna - modem

PANEL XP 2 x 18 dBi antenna 1920 - 2170 MHz LTE

Technical specification:

Model	BP-2000PL-18
Gain	18 dBi
Frequency	1920 - 2170 MHz
Vertical beam width	20 degrees
Horizontal beam width	20 degrees
Impedance	50 Ohm
Connector	2 x N(f) socket (optionally 2 x 4.3-10 (f) socket)
VSWR	1.35
Dimensions	510 / 510 / 38,1 mm
Weight	3.52 kg
Polarization	vertical, horizontal (both), diagonal -45/+45 degrees (both)
Standards	Full compatibility with LTE MIMO
Mounting	Mast handle, diameter from 1/2 to 7/4 inch (allows full rotation and azimuth correction).
Wind load	frontal: 455 N (at 125 mph) rearside: 416 N (at 125 mph) lateral: 21 N (at 125 mph)

Radiation patterns:


Azimuth H	Elevation H

Azimuth V	Elevation V